我用的是4通道鉑電阻輸入溫度調節模塊,使用GX-configurator設置參數:溫度輸入范圍5(-200-600度),TCRT模塊默認的溫度輸入小數點是1位,那么設定SV應該是多大呢?
假設我設置目標值是100。C,SV應該設定成1000呢還是100?
還有使用GX-configurator時,可不可在觸摸屏上更改SV呢?
我設定好參數后,模塊沒有報警,也沒有出錯,怎么就是不加熱呢?
控制參數:
ch1 target value setting:500
ch1proprotion setting:30
ch1 integral time setting:240S
ch1 differential(D) time setting: 60S
ch1 output control cycle setting:10S
ch1 control response parameter:fast
ch1 stop mode setting: monitor
PID continue flag:stop
報警參數:沒有設定
other setting:
ch1 upper limit settin limiter: 200
ch1 lower limit setting limiter: 0
ch1 forward/reverse operation setting: reverse operation
ch1 change rate limiter setting: 400
ch1 sensor correction value setting 1
ch1 temporary delay digital filter setting 10
ch1 upper limit output limiter 400
ch1 lower limit output limiter: 0
ch1 sensor adjustmetn (nonsensitive setting):5
ch1 at Bias:0
ch1 auto tuning mode selection:standard mode
operation level resolution change:1
temperature rise complete sock time setting:0
[ 此帖被damoguyan在2010-04-06 21:48重新編輯 ]